tibelec 976060 Manual De Uso página 13

1. Connect the black probe to terminal COM and the red probe to terminal VmAΩ
2. Set the function switch to 9V position
3. Connect the test plungers to the battery terminals and read the value dis
played on screen once it has stabilised
When the symbol appears, replace the battery with a new one.
1. Set the selector switch to Off
2. Remove the protective cover
3. Loosen the 2 screws on the back of the tester
4. Open and replace the battery in the corresponding area with a battery of
the same type (6F22 9V)
5. Tighten again.
The consumer is obliged by law to recycle all used batteries and accumulators.
It is forbidden to throw them in the ordinary bin! Refer to the environmental
protection details.
Protected by
standard fuse
Certified in accordance
with European standards
Risks resulting from
hazardous voltages
Class II equipment
without ground
connection
Do not dispose of
appliances bearing
this symbol with
domestic waste.
Use a suitable
collection point.
No protection
against water
IP20
13