Publicidad
Idiomas disponibles
Idiomas disponibles
4. Advanced operation
a.TWS pairing
Simply take the earbuds out of the charging
case or turn them on as it has been instructed
previously. The earbuds LED indicator will blink
as the earbuds sync with each other
automatically, and then enter into mobile
pairing mode.
Note: Before installing this product, please
make sure your device is Bluetooth
b. Pairing the earbuds with your mobile
device
1. Turn both earbuds on by removing them
from the charging case or pressing the
multifunction button for 3 seconds. Both
earbuds will automatically pair.
2. Set your Bluetooth
®
"discover" the wireless earbuds.
3. Place the earbuds and your phone not more
than three feet from each other.
4. On your mobile phone, tap the newly
discovered audio device KTE-750 being
displayed in the Bluetooth
5. When the mobile device asks if you want to
pair with it, click Yes or OK to accept.
6. If pairing is successful the "Done" prompt will
compatible.
®
mobile device to
list.
®
be heard.
7. If after 60 seconds the pairing process fails,
please repeat steps 1 through 5 as described
above.
8. The earbuds will automatically go into
standby mode after a short period of
inactivity to save battery life.
9. You only need to pair the earbuds with
your mobile phone once, as they will
reconnect with memorized devices
automatically.
Note: Either one of the earbuds may be used
at a time. You can switch between the
earbuds as you wish. Remove one earbud
from the charging case and it will pair within
20 seconds.
c. Using the wireless earbuds
1. Answering and ending a call
• When there is an incoming call, your phone
will ring along with a tone through your
earbuds.
• Press the multifunction button once on any
earbud to pick it up. You may also press the
answer button on your mobile phone to
Publicidad
