Publicidad
Idiomas disponibles
Idiomas disponibles
You are cautioned that any changes or
modifications not expressly approved in this
manual could void your authority to operate this
unit.
This unit must not be co-located or operated
in conjunction with any other antenna or
transmitter.
This unit complies with FCC radiation exposure
limits set forth for an uncontrolled environment
and meets the FCC radio frequency (RF)
Exposure Guidelines. This unit should be
installed and operated keeping the radiator at
least 20 cm or more away from person's body.
Compliance with FCC requirement 15.407(c)
Data transmission is always initiated by
software, which is passed down through the
MAC, through the digital and analog baseband,
and finally to the RF chip. Several special packets
are initiated by the MAC. These are the only ways
the digital baseband portion will turn on the RF
transmitter, which it then turns off at the end of
the packet. Therefore, the transmitter will be on
only while one of the aforementioned packets is
being transmitted. In other words, this unit shall
automatically discontinue transmission in case
of either absence of information to transmit or
operational failure.
Frequency Tolerance: ±20 ppm
For customers in Canada
This unit contains licence-exempt transmitter(s)/
receiver(s) that comply with Innovation, Science
and Economic Development Canada's licence-
exempt RSS(s). Operation is subject to the
following two conditions:
(1) This unit may not cause interference; and
(2) This unit must accept any interference,
including interference that may cause
undesired operation of the unit.
This unit complies with ISED radiation exposure
limits set forth for an uncontrolled environment
and meets RSS-102 of the ISED radio frequency
(RF) Exposure rules. This unit should be installed
and operated keeping the radiator at least 20 cm
or more away from person's body.
5 150 MHz – 5 350 MHz band is restricted to
indoor operations only.
Data transmission is always initiated by
software, which is passed down through the
MAC, through the digital and analog baseband,
and finally to the RF chip. Several special packets
are initiated by the MAC. These are the only ways
the digital baseband portion will turn on the RF
transmitter, which it then turns off at the end of
the packet. Therefore, the transmitter will be on
only while one of the aforementioned packets is
being transmitted. In other words, this unit shall
automatically discontinue transmission in case
of either absence of information to transmit or
operational failure.
About recommended cables
Properly shielded and grounded cables and
connectors must be used for connection to host
computers and/or peripherals.
EN
3
EN
Publicidad
