Publicidad
Idiomas disponibles
Idiomas disponibles
Error 38
It wasn't possible to measure correctly. Move
the speaker or microphone position a little
and try again. If noisy, measure with as little
surrounding noise as possible.
Warning 40
Measurement complete, but it is noisy. It may
be possible to measure again, but it is not
possible to measure in all environments.
Measure with as little surrounding noise as
possible.
Warning 41, Warning 42
The input from the measurement
microphone is excessive. The speaker and
microphone may be too close. Place the
speaker and microphone away from each
other. If using this unit as a preamplifier, this
message may be displayed depending on the
connected power amplifier, but it can be used
as it is.
Warning 43
The subwoofer distance and phase could not
be measured. Noise may be the cause. Re-
measure in a quiet surrounding environment.
Warning 44
Measurement finished, but the center
speaker positional relationship may be
unsuitable. Check the speaker position
referring to "Installing speakers" in the Help
Guide.
* The speaker name in this warning message
depends on the detected symptom.
60
EN
Precautions
On safety
Should any solid object or liquid fall into
the cabinet, unplug the receiver and have
it checked by qualified personnel before
operating it any further.
On power sources
• Before operating the receiver, check that
the operating voltage is identical with your
local power supply.
The operating voltage is indicated on the
nameplate on the back of the receiver.
• If you are not going to use the receiver
for a long time, be sure to disconnect the
receiver from the wall outlet. To disconnect
the AC power cord (mains lead), grasp the
plug itself; never pull the cord.
• The AC power cord (mains lead) must be
changed only at a qualified service shop.
• To reduce the risk of electric shock, the
speaker cable should be connected to the
apparatus and the speakers in accordance
with the following instructions.
1) Disconnect the AC power cord from the
MAINS.
2) Strip 10 to 15 mm of the wire insulation of
the speaker cable.
3) Connect the speaker cable to the
apparatus and the speakers carefully
so as not to touch the core of speaker
cable by hand. Also disconnect the AC
power cord from the MAINS before
disconnecting the speaker cable from
the apparatus and the speakers.
On heat buildup
Although the receiver heats up during
operation, this is not a malfunction. If you
continuously use this receiver at a large
volume, the cabinet temperature of the top,
side and bottom rises considerably*. To avoid
burning yourself, do not touch the cabinet.
* The top of the cabinet may become too hot to
touch.
Publicidad
