Publicidad
Idiomas disponibles
Idiomas disponibles
lnstallation
Install the exhaust duct into the wall
1. Prepare a hole in the wall.
Install the wall exhaust
adaptor onto the wall by
using 4 expansion screw
sleeve and type C screws,
be sure to fix thoroughly.
2. Connect the exhaust duct
to wall exhaust adaptor.
(Fig. G)
Note: 1. The duct can be compressed to 270 mm minimum and extended to 1500 mm
maximum. It is better to keep the duct length to a minimum length.
2. Stretching or bending the duct excessively will affect the cooling efficiency.
(As the following fig. Shows)
Without installation
If the unit does not have the window slider kit and wall exhaust, and the Adaptor B is like
this ,as shown in Fig H. You can open the window slightly and position as shown in Fig I.
Note: Cover the hole
using the adaptor cap
when not in use.
Fig. H
Expansion screw sleeve
position
Maximum: 120 cm
Minimum: 30 cm
Fig. I
49
Wall
exhaust
adaptor
Adaptor
cap
Adaptor B
(round
mouth)
Fig. G
Publicidad
