FULTON XLT 7.0 Manual De Instrucciones página 13

3.1 Strap Replacement
1. Disengage the clutch knob.
2. Un-spool the entire strap.
3. Remove the clutch knob and side cover as shown.
Figure 11 - Replacing The Strap
4. Remove the two bolts from the split collar.
5. Remove the split collar.
Figure 12 - Remove SplitCollar
6. Remove the worn strap and the strap
retaining pin.
Figure 13 - Remove Strap Retaining Pin
©2021 Horizon Global Americas Inc. •
Maintenance
Removable Cover
Clutch Knob
Retaining
Pin
7. Insert the strap through the Hawse fairlead and insert
the strap retaining pin through the strap loop.
Figure 14 - Install New Strap
8. Insert the strap retaining pin and strap into the
groove on the winch drum.
9. Replace the split ring collar and torque bolts to
24 ft.-lbs.
Figure 15 - Install Retaining Pin & Split Collar
10. Replace the side cover.
11. Replace the clutch knob. Torque to 12 ft.-lbs.
12. Wind strap onto drum by pushing and holding the
"LINE IN" button until the strap is spooled onto the
drum. Keep tension on the strap while it is winding.
Figure 16 - Replace Cover & ClutchKnob
Be sure that the strap is under-wound.
F4088-00 REV D (7871) 08/2021
E13