FULTON XLT 7.0 Manual De Instrucciones página 6

Mounting Hardware Requirements
Refer to Table 2 below for bolt quantity, sizes, and required torque. Mounting system will dictate bolt
length.
WARNING
ALWAYS torque mounting bolts to the values specified for your winch in Table 2.
ALWAYS use grade 5 (class 8.8 metric) hardware.
NEVER weld mounting bolts.
ALWAYS choose the proper bolt length for your application.
ALWAYS confirm required bolt length to ensure proper thread engagement. A minimum of two whole
threads should protrude from the nut.
Powered Winches
Winch Mounting Bolt Size
Winch Mounting Bolt Torque
1.2 Select Mount Location
WARNING
ALWAYS choose a mounting location that is sufficiently strong to withstand the maximum
pulling capacity of your winch.
The winch should be positioned so that the
strap exits the winch horizontal to the bow
eye when the boat is fully loaded onto the
trailer.
The fairlead should be a minimum of 6" away
from the bow eye when the boat is fully loaded
onto the trailer. See Figure 2.
1.2.1 Winch Mounting
Considerations
Your mounting surface must be equal to or
greater than the mounting surface of the
winch frame. See Figure 3. Three sets of
3/8", Grade 5, hardware are required to
mount this winch.
©2021 Horizon Global Americas Inc. •
E6
Installation Instructions
Table 2 - Mounting Torque Requirements
XLT 7.0
• Three 3/8"-16 Gr. 5 carriage bolts
• Three 3/8" retaining washers
• Three 3/8" NY-Lock nuts
28-30 ft./lbs.
XLT 10.0
• Three 3/8"-16 Gr. 5 carriage bolts
• Three 3/8" retaining washers
• Three 3/8" NY-Lock nuts
28-30 ft./lbs.
Figure 2 - Mount Location
Minimum distance
from the bow eye to
the winch, when the
boat is fully loaded
on to the trailer
Figure 3 - MountingSurface
F4088-00 REV D (7871) 08/2021
6"
Minimum
Mounting
Area
4.5" x 6"