Publicidad
Idiomas disponibles
Idiomas disponibles
3
1
2
001910
Return the tool opener to its original position.
After installing, always make sure that the blade is
securely held in place by trying to pull it out.
CAUTION:
Do not open the tool opener excessively, or it may
•
cause tool damage.
To remove the blade, open the tool opener to the
position shown in the figure. Pull the saw blade out
toward the base.
1
001911
NOTE:
Occasionally lubricate the roller.
•
Hex wrench storage
1
014139
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
1. Blade clamp
2. Jig saw blade
3. Protrusions
1. Jig saw blade
1. Base
2. Hex wrench
2
Cover plate
007503
Use the cover plate when cutting decorative veneers,
plastics, etc. It protects sensitive or delicate surfaces
from damage. Fit it on the back of the tool base.
Anti-splintering device
2
007504
For splinter-free cuts, the anti-splintering device can be
used. To install the anti-splintering device, move the tool
base all the way forward and fit it from the back of tool
base. When you use the cover plate, install the
anti-splintering device onto the cover plate.
CAUTION:
The anti-splintering device cannot be used when
•
making bevel cuts.
Dust extraction
The dust nozzle (optional accessory) is recommended to
perform clean cutting operations.
001921
To attach the dust nozzle on the tool, insert the hook of
dust nozzle into the hole in the base.
The dust nozzle can be installed on either left or right
side of the base.
7
1. Cover plate
1
2. Base
2
1. Base
2. Anti-splintering
device
1
1. Dust nozzle
1
2. Base
2
Publicidad
