Energetics E-201 Manual De Instrucciones página 5

Assembly and activation
Connecting the computer
Data cable: Connect the data cable coming from the equipment with the
one coming from the computer [1] .
Mounting: Attach the computer to the mount on the equipment . Carefully
slide the insert sleeve on the back of the computer over the mount on the
centre post [2] .
Pay attention not do damage the data cable when sliding the computer
housing over the mount .
Hand pulse sensors: Plug the hand pulse cable into the connector on the
back of the computer [3] .
!
Not all models are equipped with hand pulse sensors, in this case
there will be no hand pulse cable!
Power supply: The computer is powered with two batteries . Make certain
that the batteries are inserted correctly (polarity +/–) .
1 2 3 3
Computer activation
The computer can be activated by pressing the MODE- key or when the user
starts to pedal .
The computer will display the training time .
Sleep mode
Should the E-201 not receive a signal for more than 4 minutes it changes into
the sleep mode . The display turns dark . To start again press any key or start
to pedal .
All values are reset .
!
If the computer does not receive a signal for more then 4 minutes
the sleep mode is activated.
EN