Publicidad
Idiomas disponibles
Idiomas disponibles
US-DC3 Performance Data Sheet
Manufacturer: Culligan International Company
9399 W. Higgins Rd., Suite 1100, Rosemont, IL 60018 USA
(847) 430-2800
Direct Connect Filter System with Cyst Reduction and Lead, Model US-DC3
Product:
Testing Conditions:
Flow Rate: 1.5 gpm (5.7 Lpm) pH: 7.5 ± 0.5
Inlet Pressure: 60 psi (4.1 bar) Temp: 50 – 77°F (10 – 25°C)
Operating Requirements:
Rated Service Life: 4,750 gallons (17,981 Liters)
Pressure Range: 10 –125 psi (69–862 kPa)
Rated Service Flow: 1.5 gpm at 60 psi (5.7 Lpm at 4.1 bar)
Temperature Range: 35 –100°F (2 – 38°C)
Substance Reduction:
This system has been certified by IAPMO R&T and tested according to NSF/ANSI 42 and NSF/ANSI
53 for the reduction of the substances listed below. The concentration of the indicated substances in
water entering the system was reduced to a concentration less than or equal to the permissible limit for
water leaving the system, as specified by NSF/ANSI 42 and NSF/ANSI 53.
While testing was performed under standard laboratory conditions, actual performance may vary.
Substance
NSF/ANSI 42 – Aesthetic Effects
Chlorine
Particulate, Class I
particles 0.5 to <1 pm
NSF/ANSI 53 – Health Effects
Cyst
Lead pH 6.5
Lead pH 8.5
WARNING: Do not use with water that is microbiologically unsafe or of unknown quality without
adequate disinfection before or after the system. Systems certified for cyst reduction may be used
on disinfected water that may contain filterable cysts.
NOTE: Substances reduced are not necessarily in your water. Filter must be maintained according
to manufacturer's instructions, including replacement of filter cartridges.
Replacement is US-DC3-R, which can be found at select retailers. It should be replaced every
year for best results. Refer to the product manual for more specific product information, installation
instructions and instructions on replacing the filter cartridge.
Influent Challenge
Concentration
2.0 mg/L ± 10%
At least 10,000 particles/ml
Minimum 50,000 mg/L
0.15 mg/L ± 10% mg/L
0.15 mg/L ± 10% mg/L
Percent Reduction Requirement/
Maximum Permissible Product Water
Concentration
≥ 50%
≥ 85%
≥ 99.95%
0.010 mg/L
0.010 mg/L
11
Actual Average
% Reduction
99.64%
99.2%
99.99%
>99.7%
>99.3%
Publicidad
