Bosch GCM18V-12GDC Instrucciones De Funcionamiento Y Seguridad página 14

22. Sliding Base Extensions – Provide extra work sup-
port. Useful when cutting long workpieces.
23. Rubber Deflector – Attaches to bottom of chute.
Deflects dust into the chute.
24. Dust Chute – Directs sawdust up and through the
elbow and to the bag.
25. Elbow – Connects the dust chute to the dust bag. Can
be rotated to direct dust.
26. Dust Bag – Has a zipper at the bottom. Bag can be
uncoupled from elbow for emptying.
27. Mechanism Lock Lever – Holds saw in full back posi-
tion for chop cuts or fully extended for transporting.
28. Link Knob – Attaches guard link to the pivot post.
29. Lower Guard Link – Allows for smooth movement of
the lower guard.
30. Clamp – Use to hold the workpiece to the table and
base – insert into clamp post location (item 39).
31. Connectivity Module Compartment – Bosch Con-
nectivity Module is used to connect the tool to Bosch
Toolbox app on a mobile device.
32. Depth Stop Screw – Turn the knob end to adjust the
blade depth for cutting grooves.
33. Depth Stop Plate – Plate can be swung out to limit the
depth of the blade travel.
34. Pivot Post – Provides support for the saw head, dust
collection system and other functional parts.
35. Axial Glide Mechanism – Allows saw to smooth-
ly slide in and out. Can be locked in full rear or fully
extended positions.
36. Bevel Scale and Pointers – Scale is large and angled
- allows user to easily read bevel angles. Pointer indi-
cates what the current angle is.
37. Bevel Post – Provides rotating support for all miter
saw parts above the table.
14
Getting To Know Your Miter Saw
38. Bevel Detent Pin (Crown Molding Setting) – When
39. Clamp Post Locations – Two vertical post holes in the
40. Miter Detent Plate Screws – Four screws accessible
41. Bevel Range Selector Knob – Allows selection of
42. Arbor Lock – Press arbor lock button to keep blade
43. Head Assembly Lock Pin – Used to lock the head
44. Glide Movement Controller – Adjusts to regulate
45. Mounting Holes for Optional Crown Stop or Length
46. Battery Bay – used to insert Bosch battery or
47. Battery Pack (sold separately)
48. Battery Pack Release button – used to remove bat-
49. Cast-in Carry Handles – Used for lifting and trans-
50. User Interface – used to select the preset speed
51. Set Screws for Laser Line Guide – used to adjust the
engaged, it locks the head assembly to the bevel angle
of 33.9° to the left or right.
base – provided to insert the clamp (item 30).
through holes in the miter scale. These screws are
loosened when adjusting position of the detent plate.
3 bevel ranges: "0-45° Left", "0-45° Right" or "Max.
Bevel Angle to 47°."
from rotating when loosening or tightening arbor bolt
during blade removal or installation.
assembly in the lower position for transporting.
movement of the glide mechanism.
Stop.
AMPShare Battery packs.
tery pack from the battery bay.
porting of saw.
levels and to indicate the status of the power tool and
battery.
laser line guides.