Bosch GCM18V-12GDC Instrucciones De Funcionamiento Y Seguridad página 23

Using the Mechanism Lock Lever
MECHANISM LOCK LEVER
The lock lever 27 is located on the rear left side of the
mechanism.
When engaged, it locks the system (item 35 – page 12)
in either the full forward or the full back position and
prevents movement while transporting the saw. When
held in the full back position, the saw is more compact
for lifting and storage. The full back position is often
used while performing chop cuts.
TO ENGAGE THE LOCK LEVER
Saw in the Full Back Position – (Fig. 10)
1. Grasp the saw's main handle (item 3 – page 12)
and push (slide) the head assembly back as far as it
goes. The upper housings will be upright and closed.
2. Lift the tab on the lock lever to engage its wedge
into the joint area between the two lower housings.
Release the lock lever tab and the main handle. The
head assembly will be locked in the full back posi-
tion.
Saw in the Full Forward Position – (Fig. 11)
1. Grasp the main handle (item 3 – page 12) and pull
(slide) the head assembly toward you as far as it
goes. The mechanism will be fully extended.
2. Lift the tab on the lock lever to engage its wedge
into the joint area between the two lower housings.
Release the lock lever tab and the main handle. The
head assembly will be locked in the full forward posi-
tion.
From Back or Forward Positions – (Fig. 12)
1. Grip the tab on the lock lever and press down until
its wedge comes out from between the two lower
housings. Release your grip; the mechanism is now
free to slide forward and back.
Adjustments
Fig. 10
27
Fig. 11
Fig. 12
27
27
23