Bosch GCM18V-12GDC Instrucciones De Funcionamiento Y Seguridad página 28

ADJUSTING 45° BEVEL STOP (SAW BLADE 45°
TO TABLE)
1. Pull up the bevel lock lever to unlock. Move the left
sliding fence fully to the left.
2. Tilt the saw assembly to the left (counterclockwise)
until it hits the 45° stop.
3. Place only the combination square's head on the
saw's table with its long flat side resting on the table
and its 45° side against the tilted blade.
4. Place an 8mm open end wrench on bolt head "F"
(see Fig. 22).
5. While turning bolt "F," watch the blade tilt – turn "F"
until the saw blade plate is in full contact with the 45°
side of the square's head (see Fig. 21).
6. If needed, adjust bevel scale pointers (item 36 –
page 12) to be in line with the bevel scale's 45° lines.
First, adjust right bevel pointer; then tilt saw head
to the right 45° stop position (see page 49 – "Bevel
Range 2 = 0-45° Right") and adjust the left bevel
pointer. Tilt the saw head to the 0° position – both
pointers should be on the bevel scale's 0° lines.
7. Push down the bevel lock lever to lock at the desired
bevel angle.
Fig. 22
4 mm
C
D
4 mm
Adjusts 0° Stop
6/4 mm
Hex Key
28
Adjustments
Combination
Square Head
Adjusting Bevel Stops
A
Holds 0°
Stop Setting
10 mm Wrench
or 10 mm
Socket
B
Contacting Contacting
Blade Table
Adjusts 45°
Right Stop
G
8 mm Wrench
Adjusts
Bevel Lock
E
Tension
17 mm Wrench
or 17 mm
Socket
8 mm Wrench
F
Adjusts 45° Left Stop
Fig. 21