Bosch GCM18V-12GDC Instrucciones De Funcionamiento Y Seguridad página 26

0° Bevel Stop – Adjustment
Procedure
CHECKING 0° BEVEL STOP SETTING
1. Hold the saw head assembly down and push in the
head assembly lock pin (item 43 – page 12) to keep
the saw in the DOWN position.
2. Slide the head assembly completely to the back and
engage the lock lever (item 27 – page 12) by lifting
up the finger tab.
3. Rotate the table to the 0° miter position.
4. Pull up the bevel lock lever to loosen.
5. Check the position of the bevel range selector knob;
it should be at the "0-45° Left" position.
6. Tilt the saw assembly to the left (counterclockwise),
then rotate to the right (clockwise) until it hits the
stop in the vertical position – this is where the saw
is currently set to make a 0° cut.
7. Push down the bevel lock lever to lock the angle posi-
tion.
8. Use a combination square to check that the blade
is 90° (square) to the table. Place the square's ruler
edge against the table and slide it to contact the
blade with the vertical side of the square's head (see
Fig. 19).
9. Check that the saw blade's plate (not teeth) is touch-
ing the square's 90° side. If the saw blade's plate is
not in full contact with the square's body 90° side,
follow the "Adjusting 0° Bevel Stop" procedures.
26
Adjustments
Kerf Screws
Fig. 19
Combination
Kerf Inserts
Contacting
Square Blade
Fig. 18