Bosch GCM18V-12GDC Instrucciones De Funcionamiento Y Seguridad página 34

User Interface (Fig. 30)
The user interface 50 is used to select the preset speed
levels and to indicate the status of the power tool and
battery.
ECO MODE
When full power is not needed, the saw's energy-sav-
ing ECO mode can be used to reduce the saw's output
power in order to extend the runtime.
If the ECO mode is active, the speed level/mode indi-
cator 50d displays the symbol "E" and "ECO" icon 50b
lights up.
SPEED PRESETS
The speed settings and the ECO mode are prepro-
grammed and can be adjusted via the 'Bosch Toolbox'
app. For more information on the 'Bosch Toolbox' appli-
cation, refer to the "Connectivity" chapter on the next
page. The table below describes the preset speeds and
ECO mode speed.
Eco
1
2
3
BATTERY CHARGE INDICATOR
When the battery charge indicator 50a is glowing
green, the battery is charged and the number of bars
shows the level of the charge.
Glowing yellow and only one bar indicates that the bat-
tery needs to be charged or replaced soon.
Glowing red and only one bar means that the battery
charge is depleted.
TEMPERATURE INDICATOR
If the temperature indicator 50g is glowing yellow, the
critical temperature of the motor, electronics or battery
has been reached. Run the power tool at no load and
allow it to cool down.
If the temperature indicator is glowing red, power tool
is overheated and will switch off. Allow the power tool
to cool down.
34
Preparing for Saw Operations
Preset Speeds
2550 /min
3000 /min
3500 /min
4000 /min
Fig. 30
50g
50f
50e
50d
SMARTPHONE STATUS INDICATOR
It is necessary to purchase and install a Bosch con-
nectivity module and install the 'BoschToolbox' app to
receive information and messages as alerted by the
smartphone status indicator. See the Connectivity
chapter on the next page.
Green Smartphone status indicator 50e means that
there is non-critical information available in the 'Bosch
Toolbox' app for user to read.
Yellow smartphone status indicator 50e means that
there is important information available (e.g. tempera-
ture warning).
Red smartphone status indicator 50e means that there
is critical information available. It is recommended that
the user reviews the message immediately.
POWER TOOL STATUS FRAME
Green light of the power tool status frame 50f means
everything is functioning properly.
Yellow light means that:
a. Critical temperature has been reached (the tem-
perature indicator 50g is also glowing yellow) - run
the tool at no load and allow it to cool down, or
b. Battery is almost depleted (the battery charge indi-
cator 50a is also glowing yellow) - charge or replace
the battery soon.
Red light means that:
a. The tool is overheated (the temperature indicator
50a is glowing red) – turn the tool off and on again,
or
b. Battery is depleted (the battery charge indicator
50a is also glowing red) - charge or replace the
battery.
Flashing blue light means that the power tool is con-
nected to a mobile device or settings are being trans-
ferred. The user must press the user interface button
50c to accept and store the new setting(s).
50a
50b
50
50c