Bosch GCM18V-12GDC Instrucciones De Funcionamiento Y Seguridad página 61

Troubleshooting Guide - Electrical
PROBLEM
Brake does not stop blade in about 5
seconds.
Motor does not start.
Troubleshooting
CAUSE
1. Blade bolt loose.
2. Other.
1. Battery pack not charged.
2. Battery pack not installed properly.
3. Battery pack temperature is too hot
or cold for operation.
4. Electronic Motor Protection turned
tool off.
5. Burned out switch.
6. Other.
CORRECTIVE ACTION
1. Tighten blade bolt.
2. Authorized service.
1. Charge battery if needed.
2. Confirm battery is locked and
secured to the tool.
3. Let battery sit a few minutes or
until it reaches normal operating
temperature.
4a. Remove battery an replace.
4b. Let tool sit a few minutes or until
it reaches normal operating tem-
perature.
5. Have switch replaced by an Autho-
rized Bosch Service Center or Ser-
vice Station.
6. Authorized service.
61