Publicidad
Idiomas disponibles
Idiomas disponibles
PACKING AND MOVING
Before unpacking the product, memorize the position of each accessory in case you need to repack
it in the future.
Do not lift or pull the door during transport and do not use it as a support.
When moving, the appliance must not be tilted more than 45 degrees (the angle with respect to the
vertical direction). Please avoid subjecting the appliance to strong vibrations and bumps, as these
could affect its operation. Never place the appliance horizontally or upside down. Place it on its base
and move it to the desired location using its castors.
INSTALLATION
•
Before connecting your fridge to the power supply, check that the voltage indicated on the
product label corresponds to the voltage in your home. A different voltage could damage the
appliance.
•
The appliance must be grounded. The manufacturer is not responsible for any damage that may
occur as a result of ungrounded use.
•
The fridge must be placed on a completely flat surface; allow 5 and 10 cm on each side of the
appliance, 7'5 cm between the back and the wall, and allow 10 cm between the top of the
appliance and the ceiling. An incorrect location could increase the noise of the appliance.
•
Choose a well-ventilated place, where the appliance is not exposed to sunlight, high temperature
or humidity, as the latter may cause stains.
•
It is recommended to install the appliance in a place where the ambient temperature is between
16°C and 38aC. Outside this range, the internal temperature of the appliance may vary from that
set by the user.
•
If the appliance tips over for any reason, wait 10 minutes before returning it to its original position.
This allows the refrigerant system pressure to equalize before turning it back on.
•
To move the appliance, disconnect it from the power supply and remove all food inside.
Your appliance uses isobutane (R600a) as a refrigerant.
Although R600a is a natural and environmentally friendly gas, it is flammable. Therefore, you should
be careful during transportation and installation of the product. In the event of a leak, move the fridge
away from open flames or heat source and ventilate the room where the appliance is located for a
few minutes.
REVERSIBLE DOOR
The side for which the fridge door opens can be altered from the right side to the left side, in case
your installation site requires it.
When replacing the door, make sure that the appliance is completely turned off and disconnected
from the power supply.
Note: it is recommended to call a technician or a specialized person to change the opening side of
the door.
33
Publicidad
