MIYOTA JS10 Manual De Instrucciones página 3

2.SEPARATED PARTS
Setting stem x1
Code
Length from movement center to far end
of setting stem
Thread.................................
3.OTHERS
* Measurement of time rate
The unit (gate) time of measurement must be set at "10 sec." or integer fold
value of 10 sec. owing to the DFC system, and the measurement must be
performed in the form of complete watch.
* Marking on movement
* Typical clearance
4. INSTRUCTIONS MANUAL
A) DISPLAYS AND BUTTONS
Stopwatch
minute hand
Hour hand
NORMAL
Second hand
B) SETTING THE TIME
1. Pull the crown out to the 1st position.
2. Turn the crown to set hour and minute hands.
3. When the crown is pushed back to the normal position in synchronization with a time
signal, second hand begins to run.
JAPAN
MIYOTA CO.
NO JEWELS
Mov't - Caseback
Top of hands - Glass
* subject to the glass, case structure, and the length of hand
JS00
065-505
20.03mm
Ф0.9mm x 11.68mm
minimum 150 microns
300 - 400 microns *
Minute hand
Button A
24 hour hand
1st Click Position
Normal crown
position
Button B
Stopwatch
second hand