Publicidad
Idiomas disponibles
Idiomas disponibles
4.
How to operate the clamp
IPSTARTEC11 lifting clamps are suitable for horizontal (with flanges horizontal) lifting, transport,
EN
stacking and controlled tilting of steel IPE- en HEA-profiles.
06
See illustrations 3 - 13 for part reference.
Lifting
1. Open the clamp by pulling the latch lever (A) towards the hand grip (X). Place the clamp
securely and as far possible over the profile (3).
2. Release the latch lever, so that the clamp stays in pretensioned position on the profile. The pivot
(C) must be fully in touch with the profile to be lifted (4).
3. Bring the guiding wheel (H) in lift position. The chain (Z) must be completely untensioned and
always behind the guiding wheel (H). The load can now be lifted (5).
4. As soon as the load is at its destination let the crane hook descend until the clamp is fully free
of load, meaning that the lifting chain is no longer taut.
5. Keep the latch lever (A) against the hand grip (X), so that the clamp can be removed from the
load. The clamp may now be used again immediately (7).
Tilting
1. Open the clamp by pulling the latch lever (A) towards the hand grip (X). Place the clamp
securely and as far possible over the profile (8).
2. Release the latch lever, so that the clamp stays in pretensioned position on the profile. The pivot
(C) must be fully in touch with the profile to be lifted (9).
3. Bring the guiding wheel (H) in tilt position. The chain (Z) must be completely untensioned and
always behind the guiding wheel (H). The load can now be lifted (10).
4. Pull gently the chain taut. By proceeding the lift, the beam will tilt around point R and will keep
on hanging skew as soon as it goes up from the ground. Without too much effort the beam can
be fixed in any desired position when putting down the beam (11).
5. As soon as the load is at its destination let the crane hook descend until the clamp is fully free
of load, meaning that the lifting chain is no longer taut.
6. Keep the latch lever (A) against the hand grip (X), so that the clamp can be removed from the
load. The clamp may now be used again immediately (13).
5.
A reliable clamp, a secure basis for lifting
10 Year warranty preventive maintenance procedure:
Parts should be replaced only when they no longer meet our standards.
10 Year warranty repair procedure:
During every repair service the most critical parts, being pivot and camsegment will be replaced.
Please consult www.thecrosbygroup.com/resources/crosbyip-10-year-guarantee for more infor-
mation on maintenance procedures.
Maintenance without 10 year warranty: Annually clamps are subjected to inspection* and parts will
be replaced only when they no longer meet our standards.
*CrosbyIP authorised repairer
Copyright © 2021 The Crosby Group LLC. All Rights Reserved.
Publicidad
