Publicidad
Idiomas disponibles
Idiomas disponibles
4. Repeat step 2 and 3 with the pipe (B2) on the
other side of the fiiter.
5. Connect the end of pipe (B2) to one of the
adapters " D " or " E and F " which suits to the
water main ( Fig .4).
6. Remove the plug in the valve at the back of
appliance( Fig .5).
7. Connect the end of B1 to the valve at the
back of the appliance( Fig .6).
8.Open the water tab to check if the system is
leak free and flush the pipe .
WARNING!
▶ Ensure that the connections are always firm , dry and leak free .
▶ Make sure the hose is never crushed , kinked , or twisted .
Aligning the appliance
The appliance should be placed on a flat and
solid surface .
1. Tit the appliance slightly backwards ( Fig .7) .
2. Set the feet to the desired level . Make sure
the distance to the wall on the hinge sides is at
least 10 cm .
3. The stability can be checked by alternately
bumping on the diagonals . The slightly swaying
should be the same in both directions . Other-
wise the frame can warp ;possible leaking door
seals are the result . A low tendency to the rear
facilitates the closing of the doors .
Installation
Fig.7
Fig.4
EN
Fig.5
Fig.6
37
Publicidad
