Domo DO227SV Manual De Instrucciones página 33

5. The rotating floor brush may be rinsed off under running water. Make sure that it is completely dry
before using it.
6. Place the floor brush back into the floor nozzle when it is clean.
7. Replace the cover on the floor nozzle and tighten it back into place. Pay attention to the lock
symbol.
8. Push the nozzle back onto the stick. The machine is now again ready for use.
Stuck hairs can damage the machine or your floor. Always remove the hairs stuck on the brushes.
PROBLEM AND SOLUTION
Problem
The machine does not start up.
The machine does not vacuum.
The running time of the machine is
shorter and shorter.
The indicator light does not burn
while charging.
SPECIFICATIONS
Published information
Linea 2000 BV – Dompel 9 – 2200
Herentals – Belgium
Model number
Supply voltage
Power frequency
Output voltage
Output current
Output power
Average active efficiency
Efficiency at low load
Non-loaded energy consumption
www.domo-elektro.be
· The battery is empty. Charge the machine.
· The battery is not inserted properly. Insert the battery until
it clicks into place.
· The filters are dirty/the dust reservoir is full.
· The floor nozzle is clogged/the floor brush is blocked.
· The nozzle opening is clogged.
· Stuck hairs. Remove the hairs stuck on the brushes.
· Clean the machine as described in this manual.
· The machine is not sufficiently charged. Charge the
machine fully and try again.
· The battery is broken or old. Replace the battery.
· There is poor contact.
· Check that the adapter is connected properly.
· Remove the dust on the connector of the upright vacuum
cleaner.
Value and precision
DO227SV
100-240
50-60
25.0 – 29.0
0.8
20.0 – 23.2
88.4
83.0
0.08
Solution
-
Unit
-
-
V
Hz
V
A
W
%
%
W
33
DO227SV