Johnson JSMV2 Serie Manual De Instrucciones página 48

Avoid button:
2
1. . In any mode of boot, press the button to turn on the function.
2. Press ,
3 Power button: Operation starts when this button is pressed and stops
when you press the button again.
Fan button: This button is used to select the desired fan speed. Each time
4
you push the button, the fan speed is shifted in the following sequence:
LOW MED
Fan speed display:
1 2
Select LOW fan speed and zones 1~2 will illuminate.
Select MED fan speed and zones 1~4 will illuminate.
Select HIGH fan speed and zones 1~6 will illuminate.
Select AUTO fan speed and zones 1~7 and "AU" will illuminate.
Note: When using the remote control to choose strong wind, wind speed 1~7
will illuminate.
Swing button:
5
1. This button is used to set the horizontal and vertical airflow.
2.Each time the airflow direction button is pressed, the settings change
as follows: Set vertical airflow→ Cancel vertical airflow→ Set horizontal
airflow→ Cancel horizontal airflow > Set simultaneous vertical and
horizontal airflow→ Cancel simultaneous vertical and horizontal airflow→
Set horizontal airflow.
WARNING: Manually moving the horizontal and vertical airflow
direction louvers could damage the air conditioner.
button
6
Temperature adjust: Press
of 16°C/17°C~30°C(60°F/62°F~86°F) or 20°C~28°C(68°F~82°F).
Under test run operation, pressing
error codes.
or button to stop this function.
HIGH AUTO
4
6
7
and to adjust the temperature in a range
and can display the protection or
V.3
10