Jonsered CS 2240S Manual De Instrucciones página 7

Symbols on the mac hine:
W ARNING! Chain saws can be
dangerous! Careless or improper use can
result in serious or fatal injury to the
operator or others.
Please read the operator's manual
carefully and make sure you
understand the instructions before
using the machine.
Always wear:
• Approved protective helmet
• Approved hearing protection
• Protective goggles or a visor
Both of the operator ' s hands must be
used to operate the chain saw.
Never operate a chain saw holding it
with one hand only.
Contact of the guide bar tip with any
object must be avoided.
Recommended cutting
equipment in this example: -
Bar length 15 inches - Max.
nose radius 10 Teeth - Chain
type Jonsered H30
Other approved bar and chain
combinations in Operator's Manual.
Measured maximum kickback value
without triggering the brake, for the bar
and chain combination on the label.
WARNING! Kickback may occur when
the nose or tip of the guide bar touches
an object, and cause a lightning fast
reverse reaction, kicking the guide bar
up and towards the operator. May cause
serious personal injury.
Chain brake, activated (right) Chain
brake, not activated (left)
Ignition; choke: Set the choke control
in the choke position. This should
automatically set the stop switch to the
start position.
1153144-49 Re v .6 2016-12-23
KEY T O SYMBOLS
Air purge.
Refuelling.
Chain oil fill.
Adjustment of the oil pump.
Other symbols/decals on the mac hine refer to special
certification requirements for certain markets.
The engine exhaust from this product
contains chemicals known to the State
of California to cause cancer, birth
defects or other reproductive harm.
–
English 7