Powerplay SPYDER SPY1500V Instrucciones De Montaje, Cuidado Y Uso página 6

Operating Instructions
1. Turn on water supply at the faucet.
2. Make sure the "ON/OFF" switch is in the "OFF"
position. The power switch has international
symbols: On (|) Off (O).
3. Completely unwind the power cord and plug into a
grounded 120 volt outlet.
4. Release the spray gun safety lock (I) on the spray gun (H).
Point the spray gun in a safe direction and squeeze the
trigger until there is a steady stream of water, releasing
water and air out of the hose. Lock the spray gun.
5. Turn the power switch to the "ON" (|) position. The unit
will run on for 1 - 2 seconds and shut off. This is a normal
function of the auto-start feature.
6. Begin power washing by squeezing the trigger all the way
into the handle.
7. Release the trigger to stop the power washer.
8. Allow the motor to come to a complete stop before
squeezing the trigger again.
9. Squeezing the trigger rapidly will cause the auto-start
feature to miss an on/off cycle and may prevent the
washer from turning on. Use slow, deliberate trigger pulls
to avoid this.
10. ALWAYS test a small area to avoid damaging the surface.
Using High/Low Nozzle
The spray pattern and intensity can be adjusted for each
task by twisting the spray nozzle at the far end of the lance.
• Twist the nozzle head clockwise for the high pressure
(pencil stream) setting.
• Twist the nozzle head counter clockwise for the low
pressure (fan spray) setting.
Pencil Stream
Fan Spray
Operation Tips
• When using detergent, fill bottle with a properly
formulated detergent-to-water ratio, following
instructions on the container.
• It is normal to hear the motor run intermittently when
the trigger is not being squeezed. The pump is priming
itself to operate when the trigger is squeezed.
• Turn off the power washer if not being used after five
minutes.
• The O-rings in the hose should be cleaned regularly
and lubricated with non-water soluble grease such as
petroleum jelly.
• Keep the cleaning wire nearby for unclogging the
spray nozzle.
How to Avoid Damaging Surfaces
• Damage to surfaces being cleaned occurs when
the impact force of the water pressure exceeds the
durability of the surface. Bare wood can be penetrated;
paint can be peeled off, etc. You can vary the force of
the power washer by adjusting:
1. The angle of the nozzle to the surface being
cleaned.
2. The distance from the nozzle to the surface being
cleaned.
• NEVER use a narrow, high-pressure stream of water on
soft surfaces.
10
Operating Instructions
Cleaning Garden Hose Adapter
The screens inside the garden hose adapter should be
cleaned periodically.
1. Rinse with clean water.
2. Place back into the adapter.
Using the Foam Cannon
1. Detach the lance from the high pressure gun.
2. Unscrew fluid tank from foam cannon valve assembly.
3. Fill fluid tank with water (for best results, use warm
water.)
4. Add 1-3 ounces of your favorite detergent to the fluid
tank.
5. Attach fluid tank to foam cannon valve and attach
assembly to the gun. Use the control knob to change the
flow of soap + (more) or - (less).
6. When finished, run clean plain water through the
pressurized foaming system to purge soap from the
internal components.
Flush with hot water for added cleansing power.
11