Stalgast KG-1 Manual página 40

Thermal
Alignmentof air
power of the
shutter (mm)
burner (kW)
14,0
9,0
7,0
5,0
3,5
14,0
9,0
7,0
5,0
3,5
14,0
9,0
7,0
5,0
3,5
11,0
9,0
7,0
5,0
3,5
9,0
7,0
5,0
3,5
11,0
9,0
7,0
5,0
3,5
11,0
9,0
7,0
5,0
3,5
8.3. Installation
The appliance may be connected to a gas installation or gas cylinder, and only by a person authorized to
perform tting services. Adaptations of the stove to another type of gas must be carried out by an autho-
rized tter
• After unpacking make sure that the unit does not show any visible damage. If the unit has been dama-
ged during transport, do not connect it!
• The protective foil must be removed from the unit before the start-up. Wash the outer surfaces with
a cloth wet in warm water and degreasing agent, and then dry them out. Do not use any agents that
could scratch the surface.
• Facilities in which gas appliances are to be installed must comply with the installation regulations of
the country, in which they are to be installed.
• The appliance should be positioned in a well-ventilated room. It is necessary to ensure a unblocked
in ow of air to the stove (it is necessary during the gas combustion process) as well as safe exhaust
discharge (do not place the stove in recessed parts, do not block it with high appliances/cabinets aside,
etc.). When the kitchen is placed against a wall, the minimum distance should be as follows:
• from a non- ammable wall according to installation possibilities,
• from a protected ammable wall, i.e. a wall made of ammable materials, but rendered or
protected in an evenly distributed manner - not less than 30 cm
• from an unprotected ammable wall, i.e. a wall made of wood or other ammable mate-
rials - not less than 60 cm
• Appliances adapted for combustion of LPG must not be installed below the grade level (e.g. basements).
Setting the burner shutter
Type of
gas
H = 21 G27
H = 16 G27
H = 14 G27
H = 14 G27
H = 14 G27
H = 19 G20
H = 14 G20
H = 12 G20
H = 12 G20
H = 12 G20
H = 21 G20
H = 16 G20
H = 14 G20
H = 14 G20
H = 14 G20
H = 24 G30/31
H = 22 G30/31
H = 20 G30/31
H = 20 G30/31
H = 20 G30/31
H = 12 G25,3
H = 8 G25,3
H = 8 G25,3
H = 10 G25,3
H = 24 G30/31
H = 21 G30/31
H = 19 G30/31
H = 19 G30/31
H = 19 G30/31
H = 24 G30/31
H = 18 G30/31
H = 16 G30/31
H = 16 G30/31
H = 16 G30/31
Gas pressu-
re (mbar)
20
20
20
20
20
25
25
25
25
25
20
20
20
20
20
30
30
30
30
30
25
25
25
25
37
37
37
37
37
50
50
50
50
50
- 40 -