Airwell CDMX-022N-09M25 Manual De Instalación página 42

Panel Installation
CAUTION
DO NOT place the panel facedown on the
floor, against a wall, or on uneven surfaces.
(A)
Super-Slim models
Step 1: Remove the front grille.
1. Push both of the tabs towards the middle
simultaneously to unlock the hook on the
grille.
2. Hold the grille at a 45° angle, lift it up
slightly and detach it from the main body.
Step 2: Remove the installation covers at the
four corners by sliding them outwards.
Step 3: Install the panel
Align the front panel to the main body, taking
into account the position of the piping and
drain sides. Hang the four latches of the
decorative panel to the hooks of the indoor
unit. Tighten the panel hook screws evenly at
the four corners.
NOTE: Tighten the screws until the thickness
of the sponge between the main body and the
panel reduces to 4-6mm (0.2-0.3"). The edge of
the panel should be in contact with the ceiling
well.
Page 41
 
Adjust the panel by turning it to the arrowed
direction so that the ceiling opening is
completely covered.
Latch
Piping side
Drain side
Screwdriver
1. Connect the two louver motor connectors
to the corresponding wires in the control
box.
Control box
Connect the
louver motor
2. Remove foam stops from inside the fan.
3. Attach the side of the front grille to the
panel.
4. Connect the display panel cable to the
corresponding wire on the main body.
5. Close the front grille.
6. Fasten the installation covers at all four
corners by pushing them inwards.
NOTE: If the height of the indoor unit needs
to be adjusted, you can do so through the
openings at the panel' s four corners. Make
sure that the internal wiring and drainpipe
are not a ected by this adjustment.
Connect the
louver motor