Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY STEP 6
INSTALL THE SPROCKET COVER
1. Position the sprocket cover over the sprocket as shown and fasten to the
mounting plate with #8x3/8" hex screws provided.
You have now finished assembling your garage door opener. Please read the
following warnings before proceeding to the installation section.
HARDWARE SHOWN ACTUAL SIZE
INSTALLATION
IMPORTANT INSTALLATION INSTRUCTIONS
To reduce the risk of SEVERE INJURY or DEATH:
1. READ AND FOLLOW ALL INSTALLATION WARNINGS AND INSTRUCTIONS.
2. Install garage door opener ONLY on properly balanced and lubricated garage
door. An improperly balanced door may NOT reverse when required and could
result in SEVERE INJURY or DEATH.
3. ALL repairs to cables, spring assemblies and other hardware MUST be made
by a trained door systems technician BEFORE installing opener.
4. Disable ALL locks and remove ALL ropes connected to garage door BEFORE
installing opener to avoid entanglement.
5. Where possible, install the door opener 7 feet (2.13 m) or more above the
floor.
6. Mount the emergency release within reach, but at least 6 feet (1.83 m) above
the floor and avoiding contact with vehicles to avoid accidental release.
7. NEVER connect garage door opener to power source until instructed to do so.
8. NEVER wear watches, rings or loose clothing while installing or servicing
opener. They could be caught in garage door or opener mechanisms.
Hex Screw #8x3/8"
(Packed with the
sprocket cover)
To avoid possible SERIOUS INJURY to finger from moving garage door opener:
ALWAYS keep hand clear of sprocket while operating opener.
l
Securely attach sprocket cover BEFORE operating.
l
9. Install wall-mounted garage door control:
within sight of the garage door.
l
out of reach of small children at a minimum height of 5 feet
l
(1.5 m) above floors, landings, steps or any other adjacent walking
surface.
away from ALL moving parts of the door.
l
10. Place entrapment warning label on wall next to garage door control in a
prominent location.
11. Place emergency release/safety reverse test label in plain view on inside of
garage door.
12. Upon completion of installation, test safety reversal system. Door MUST
reverse on contact with a 1-1/2" (3.8 cm) high object (or a 2x4 laid flat) on
the floor.
13. DO NOT install on a one-piece door if using devices or features providing
unattended close. Unattended devices and features are to be used ONLY with
sectional doors.
12
Hex Screws
Sprocket
Publicidad
