2
Part Names
Indoor unit
81-EN
Hook
Hook to open and close the air intake grille.
Air discharge, discharge louver
Change the direction of the wind blowing out
when warming or cooling the room.
Air intake grille
Sucks in air inside the room from here.
Air filter
Removes the dust and dirt.
(Located on inside of the air intake.)
Air filter protruding section
– 46 –
3
Wired remote controller
• For using the wired remote controller RBC-AMS55E* or the wireless remote controller RBC-AX41U*, refer to the Owner's
Manual attached to the above remote controllers.
This remote controller can control the operation of up to 8 indoor units.
Display section
In the display illustration below all the icons are shown. When the unit is in operation,
only relevant icons will be displayed.
• When the leak breaker is turned on for the first time,
part of the remote controller.
• While this icon is flashing, the model is being automatically confirmed.
Wait till
icon has disappeared to use the remote controller.
7
3
4
1
2
5
6
9
18
10
20
21
1
Operation mode
The selected operation mode is displayed.
2
Check display
Displayed while the protective device works or a
problem occurs.
3
SETTING display
Displayed during setup of the timer or other settings.
4
TEST run display
Displayed during a test run.
5
Timer display
Indicates time concerning the timer.
(Indicates a check code when a problem occurs)
6
Timer mode display
The selected timer mode is displayed.
7
Louver position display
Displays louver position.
flashes on the display
TEMP.
ON / OFF
TIMER SET
FAN
MODE
TIME
SAVE
VENT
FILTER
RESET
TEST
SET
CL
SWING/FIX
UNIT LOUVER
13
8
14
12
11
15
19
16
17
8
Swing display
Displayed during up / down movement of the louver.
9
Filter display
Reminder to clean the air filter.
10
Fan speed display
The selected fan speed mode is displayed.
(Auto)
(High)
(Med.)
(Low)
11
Set temperature display
The selected set temperature is displayed.
12
Power saving mode display
Limits compressor speed (capacity) to save energy.
Display
section
Operation
section
82-EN