Publicidad
Idiomas disponibles
Idiomas disponibles
en-us
Conversion to another type of gas
8.
Put the cooktop in place and tighten the screws
evenly. Put the burner parts and pan supports in
place, and ensure that they are positioned correctly.
9.
Set the pressure regulator to the correct gas
pressure.
Replacing the Main Control Nozzles: Normal and High
Output Burners
1.
Remove the pan supports and all burner parts.
2.
Unscrew the fastening nuts from the cooktop (3 nuts –
WAF 7), and carefully lift up the cooktop to remove it.
3.
Remove the securing clips from the burner pipes. Pull
out the burner pipes. The electrode can remain
connected. Unscrew the burners (Torx T20) and pull
out the burner pipes.
4.
Remove the nozzles from the burner pipes by hand,
pull off the O-ring.
5.
Check that the O-ring fits correctly in the new main
control nozzle. Pull the nozzles off of the burner
pipes. Do not bend the burner pipes!
6.
Attach the burner pipes to the burners. Attach the
securing clips. Screw the burners into place.
16
7.
After loosening the screw, adjust the air regulating
sleeve for the external burner to the correct setting
(see nozzle table – L1). Retighten the screw.
8.
Adjust the air regulating sleeve for the inner burner by
turning or sliding it to the correct setting (see nozzle
table – L2).
9.
Put the cooktop in place and tighten the screws
evenly. Put the burner parts and pan supports in
place, and ensure that they are positioned correctly.
Setting the Gas Type
Set the gas type via any control knob:
1.
Turn the control knob to 0 (A). Disconnect the
appliance from the power supply. Wait for at least
30 seconds (B).
2.
Reconnect the appliance (C). The illuminated ring
around the control knob will turn green for a second
and then turn yellow (D). Wait until the illuminated ring
goes out.
Publicidad
