EGAmaster 79610 Manual De Instrucciones página 40

When working on or with the equipment, it is imperative to observe all legal requirements in
regards to waste-disposal and proper recycling.
In particular during installation, repair and maintenance work, water damaging agents, such as
• lubricating grease and oil,
• hydraulic fluid,
• coolant,
• solvent containing cleaning agents must not leak into the ground or reach
suitable containers!
The following table shows possible problems and their causes:
Problem
Machine does not
a
start
Machine is
b
rotating too slowly
Machine makes
c
strong noise
d Other trouble
If necessary, we ask you to send the machine to the supplier.
Unless otherwise specified, our "General Sales Terms" apply.
Warranty and liability claims in regards to persons or equipment damages are invalid, if one
or several of the following causes apply:
• Improper use of the machine.
• Improper assembly, startup, operation or maintenance of the machine.
• Operation of the machine with defect safety devices or improperly fixed or non-functioning
safety and protection devices.
• Non-observance of the instructions in the operating instruction booklet concerning transport,
storage, assembly, startup, operation, maintenance and setting up of the machine.
• Independent structural alterations or settings on the machine beyond the intended purpose
• Inadequate supervision of wear parts.
• Improperly carried out repairs, inspections or maintenance
• Catastrophic cases because of a war, acts of god or other reasons which are beyond our
control.
40
ENVIRONMENTAL REGULATIONS
the sewage system.
These materials must be stored, transported, contained and disposed of in
TROUBLESHOOTING
Cause
not connected to pneumatic
supply
Too little operating pressure
Hose diameter too small
Too little volume flow
WARRANTY AND LIABILITY
Connecting and opening of the
Increase operating pressure Choose
larger hose diameter Increase volume
- Contact authorized expert company
- Contact authorized expert company
Remedy
pneumatic line
flow