Publicidad
Idiomas disponibles
Idiomas disponibles
Greases (free of resins and
acids)
Designation in accordance
with DIN 51502
Consistency class (DIN
51818)
Saponification type
Dripping point
Worked penetration
Temperature range
42
Multi-purpose greases
for antifriction and friction
bearings and gears
265 to 295
-25ºC to 125 ºC
OILER TYPES USED ON OR WITH OUR TOOLS
Oiler to mount on the machine or connect in the hose
Setting the oiler: The adjustment screw is visible after
removing the screw plug. The oil supply is decreased
by tightening the screw, and by loosening the screw,
sufficient to tighten or loosen the screw by ¼ or ½ of a
turn. When plugged, clean borehole (diam. 2mm) with
Correct setting: When under pressure and with the filler
screw open, the oil must bubble slightly. The filling
For stationary pneumatic machines and motors,
Setting of oilers: Shut off air supply. Open plug. Loosen
screwdriver turn back the tightened screw plug by ¼ to
½ of a turn and then lock again. No oils are to get into
the borehole "a" when filling. Close plug and open the
Correct setting: A piece of paper held for a short time in
front of the outlet must be coated with oil without drops
KL 2 K
2
lithium
185ºC
more oil gets into the machine. In most cases it is
lasts for approx. 8 operating hours.
Line oiler
the lubrication is carried out by lined-up oilers for
horizontal or vertical installation.
visible lock nut with a socket wrench. Using a
air supply.
forming.
Special greases for high-
speed miter gears
G 00h
00
sodium
145ºC
400 to 410
-25ºC to 100ºC
line
wire.
Publicidad
