Silvercrest SSTMC 600 A1 Instrucciones De Uso página 11

4) Press the lid 2 firmly down onto the blender 3 . Close the lid 2 by turning
it clockwise to position
pouring spout on the blender 3 is closed . The motor cannot start until the
lid 2 is fitted flush .
Fig . 1
5) Press the measuring cap 1 into the lid as far as the stop .
6) Place the completely filled and closed blender 3 onto the motor block 6
with the handle to the right . Make sure that the arrow q on the blender 3
points to the  marking on the motor block 6 . Turn the blender attachment
3 slightly back and forth if it does not fit properly into place immediately .
The motor cannot start until the blender 3 is fitted flush to the motor unit .
Selecting the speed setting
Once the blender 3 is filled and sitting completely closed on the motor block 6,
you can switch on the appliance .
Set the switch 5 to ...
■ Level 1 – 3
for liquids or soft foodstuffs, for mixing, blending and stirring
■ Level 3 – 5
for more solid foods or for chopping
■ Level P (pulse function)
for short, powerful impulse operation, e .g . for crushing ice cubes or when
cleaning . To prevent overloading the motor, the switch 5 does not lock in this
position . Therefore, hold the switch 5 in this position for short periods only .
NOTE
► Fill the blender 3 with a maximum of 250 ml of ice cubes .
Otherwise, the ice cubes will not be crushed optimally .
■ 8 │ GB │ IE
until it audibly engages (see Fig . 2) . Ensure that the
Fig . 2
SSTMC 600 A1