Silvercrest SSTMC 600 A1 Instrucciones De Uso página 16

Cleaning
DANGER! ELECTRIC SHOCK!
Before starting to clean the blender and its components:
► Ensure that the motor is switched off and the power plug removed from the
socket .
Do not immerse the motor block 6 in water or other liquids . This could
result in you receiving a fatal electric shock and cause damage to the
appliance .
► Never open the housing of the appliance . Otherwise, there is a risk of a
fatal electric shock .
WARNING! RISK OF INJURY!
► Handle the cutting blades 4 with extreme caution . They are very sharp .
CAUTION! PROPERTY DAMAGE!
► Do not use solvents or abrasive cleaners on the plastic surfaces, they could
be damaged by them .
Cleaning the blender
■ To prevent injuring yourself on the cutting blades 4, clean the blender 3 only
with a long-handled washing-up brush .
■ Clean the measuring cap 1 and the lid 2 in mild soap solution . Ensure that
the rubber seal 9 is correctly fitted before using the lid 2 again .
NOTE
■ If you clean the appliance directly after use, you can usually achieve
sufficiently hygienic cleaning results by using the following alternatives:
Fill the blender 3 with 750 ml of water and add a couple of drops of mild
washing up liquid . Close the lid 2 and fit the blender 3 onto the motor
block 6 . Insert the mains plug into the socket and activate the pulse function
a few times so that the cutting blades 4 plough through the water at maximum
speed . Afterwards, rinse the blender 3 with plenty of clean water to remove
any washing up liquid residues .
SSTMC 600 A1
You can also clean the lid 2, the measuring cap 1 and the
blender 3 with the cutting blade 4 in your dishwasher .
GB │ IE │ 13 ■