Kohler K-15160 M Manual Del Propietário página 4

Bonnet
Stop Tab
Mounting Nut
Optional Temperature Limiting Adjustment
If desired, you can adjust the maximum allowable water temperature
setting by following the steps below.
NOTE: Before adjusting the water temperature limit, ensure that the
handle is turned all the way to the left. This is the maximum hot
position.
Remove the plug button, O-ring, and screw from the handle.
Remove the handle and bonnet from the faucet body.
Lift the valve stem up and off the stop tab. The water will turn
on.
Align the stop tab with the mounting nut to establish the
maximum water temperature.
Mark the maximum temperature on the mounting nut with a
marker or pencil.
Lift up the indexer and disk to clear the splines.
NOTE: Each spline adapter notch represents approximately 9.5°F
(5.3°C).
Turn the indexer, disk, and valve stem counterclockwise until the
temperature is properly adjusted.
Push down the indexer and disk to cover the splines after the
temperature is adjusted. Ensure that the disk is fully snapped into
the indexer.
1017405-5-E
Handle
Screw
O-Ring
Plug Button
Valve Stem
Top Disc
Indexer
Splines
4 Kohler Co.