Publicidad
Idiomas disponibles
Idiomas disponibles
- EN -
ACCESSING THE UNIT
NOTE
The following applies to all units with a heater:
• Adhere to the rules for careful handling. (→ Careful handling of the heater)
Careful handling of the heater
!
CAUTION
Hot surface!
Risk of burns when touching the glass bulb.
• Unplug the heater and allow it to cool down before removing it from the water.
!
CAUTION
Risk of breaking the glass!
The glass bulb of the heater can break and cause cuts.
• Take care when handling the heater.
• Allow the heater to cool down first. Do not immerse it in cold water or pour cold water over it.
• Take care of glass fragility when installing the heater in the adapter or the opposite operation
Removing the heater (BioMaster Thermo models)
The heater has to be removed for cleaning, maintenance, and for removing the unit head.
How to proceed:
C
1. Lift up the handle.
2. Twist the adapter counter-clockwise and pull up. Do not remove the heater from the HeatUp adapter.
• To exchange the heater: Carefully remove the original heater by moistening the glass bulb with water and
pulling the adapter off the heater. Moisten the new heater with water and push the heater into the adapter
as far as it goes.
Fitting the heater
How to proceed:
D
1. Twist the HeatUp adapter, assembled with the heater, clockwise into the threaded hole.
2. Place the heater's power connection cable into the cable guide.
3. Put the handle down.
• For retrofitting HeatUp heater in non thermo models →Retrofitting the heater P.10
Removing the inlet and outlet connection unit
The connection unit has to be removed for cleaning, maintenance, and for removing the unit head
when tubing is connected.
Prerequisite: The lever can only be moved when the pre-filter is locked.
How to proceed:
E
1. Move the lever to the "UNLOCK" position.
– The inlet and outlet are closed.
2. Remove the connection unit. Set it to the side with the tubing still connected.
Fitting the inlet and outlet connection unit
Prerequisite: The lever can only be moved when the pre-filter is locked.
How to proceed:
F
1. Fit the connection unit and push it into the unit head as far as it goes.
– Ensure that the ridges on the connection unit are correctly aligned to the recesses on the unit head.
2. Move the lever to the "LOCK" position.
– The inlet and outlet are open.
6
BioMaster 250/350/600/850, BioMaster Thermo 250/350/600/850
- EN -
7
Publicidad
