Publicidad
Idiomas disponibles
Idiomas disponibles
- EN -
COMMISSIONING/START-UP
Expelling air from the filter system
Prerequisite: The unit is unplugged. (→ Switching off the unit P.14)
How to proceed:
P
1. Press the priming button and release it until the water flows out of the tank into the filter.
– The filter is completely flooded when water emerges from the outlet assembly.
Switching on the unit
NOTE
Ensure that the pump never runs dry!
The pump will be destroyed.
• Regularly check the water level and circulation in the filter and in the aquarium.
NOTE
Risk of fire due to the hot surface of the heater! The heater and filter can be
destroyed by the generated heat.
• Do not plug in the heater until the filter is completely filled with water, plug in
and the water is continuously circulated.
• Unplug the heater and allow it to cool down before removing it from the water.
How to proceed:
Q
1. Route each power connection cable such that it forms a drip loop.
2. Connect the power connection cable to the power supply.
– The pump will switch on immediately.
– Trapped air in the filter can cause noise. The trapped air escapes shortly after the pump starts up.
3. Unit with heater: Set the water temperature on the heater and plug in the heater. (→ Heater
instruction manual).
Switching off the unit
How to proceed:
• Disconnect the unit from the power supply
• Unit with heater: Disconnect the unit and heater from the power supply
Setting the flow rate
How to proceed:
R
• Move the lever on the inlet/outlet connection unit to set the desired flow rate
– "LOCK": Maximum flow rate
– "UNLOCK": No flow, the inlet and outlet are closed
14
BioMaster 250/350/600/850, BioMaster Thermo 250/350/600/850
- EN -
15
Publicidad
