Publicidad
Idiomas disponibles
Idiomas disponibles
MANY COMMON PROBLEMS CAN BE SOLVED EASILY BY UTILIZING THE CHART BELOW. For assistance with your product,
visit our website at www.BOSTITCH.com for a list of service centers, or call the BOSTITCH Customer Care Center at
1-800-556-6696.
WARNING: To reduce the risk of serious personal injury, ALWAYS disconnect battery pack from tool before all repairs
SYMPTOM
CAUSE
Motor does not run with
Trigger lock in locked position
trigger depressed
Tool is stalled, locking the motor from rotating Rotate the stall release lever on the tool and the mechanism will release
Tool is in the sequential actuation mode
Tool internal electronics need to be reset
Motor stops running after 5 seconds
Terminals are dirty or damaged
Damaged internal electronics
Damaged Trigger
Motor does not run with
Trigger lock in locked position
contact trip depressed
Dryfire lock out engaged, blocking contact trip
from traveling fully
Tool is stalled, locking the motor from rotating Rotate the stall release lever on the tool and the mechanism will release
Bent contact trip
Motor stops running after 5 seconds
Terminals are dirty or damaged
Damaged internal electronics
Damaged Trigger
Tool does not actuate (motor
Dryfire lock out engaged, blocking contact trip
runs but will not fire)
from traveling fully
Low battery charge or damaged battery
Jammed nail/drive blade not returned to
home position
Damaged driver/return assembly
Jammed internal mechanism
Damaged internal electronics
Motor starts up but generates a
Jammed nail and driver blade is stuck in down
lot of noise
position
Damaged driver/return assembly
Drive blade continues to get
Jammed nail and driver blade is stuck in down
stuck in down position
position
Damaged driver/return assembly
Debris in nosepiece
Tool operates but does not
Depth adjust set too shallow
drive fasteners fully
Tool not firmly applied to workpiece
Material and fastener length
Damaged or worn driver blade tip
Damaged actuation mechanism
TROUBLESHOOTING GUIDE
FIX
Unlock trigger lock.
If driver blade does not return, remove battery and manually push driver
blade back to home position.
Depress contact trip first before firing or switch to bump mode.
Remove battery, wait 3 seconds and reinsert.
Normal operation, release trigger and redepress.
See authorized service center.
See authorized service center.
See authorized service center.
Unlock trigger lock.
Load more nails into magazine.
If driver blade does not return, remove battery and manually push driver
blade back to home position.
See authorized service center.
Normal operation, release contact trip and redepress.
See authorized service center.
See authorized service center.
See authorized service center.
Load nails into magazine.
Check charge level if pack shows state-of-charge Charge or replace
battery pack if necessary.
Remove battery, clear jammed nail, cycle stall release lever, (push driver
blade up manually if necessary) reinsert battery pack.
Replace driver/return assembly See authorized service center.
See authorized service center.
See authorized service center.
Use stall release lever, clear and jammed nails, and return driver blade
manually if necessary.
Replace driver/return assembly See authorized service center.
Use stall release lever, clear any jammed nails, and return driver blade
manually if necessary.
Replace driver/return assembly See authorized service center.
Clean nose area and watch closely for small pieces of broken nails stuck
in the track.
Rotate depth adjust to a deeper setting.
Apply adequate force to tool securing it tightly to workpiece See
instruction manual.
If the unit continues to stall (forcing the need to rotate the Stall release
lever) choose the appropriate material and fastener length that is not too
rigorous of an application.
Replace driver/return assembly See authorized service center.
See authorized service center.
English
13
Publicidad
