Descargar Imprimir esta página

Zenoah G621AVS Manual De Instrucciones página 30

Ocultar thumbs Ver también para G621AVS:

Publicidad

F12
F13
30
English
8. Operating the engine
6. When firing occur, push in the choke knob and pull
the starter again to start the engine.
7. Allow the engine to warm up with the throttle lever
pulled slightly.
WARNING
Keep clear of the saw chain as it will start rotatIng
upon starting of engine.
CHECKING THE OIL SUPPLY
WARNING
Make sure to set up the bar and the chain when
checking the oil supply.
If not, the rotating parts may be exposed. It is very
dangerous.
After starting the engine, run the chain at medium
speed and see if chain oil is scattered off as shown in
the figure. (F12)
(1) Chain oil
The chain oil flow can be changed by inserting a
screwdriver in the hole on bottom of the clutch side.
Adjust according to your work conditions. (F13)
(1) Chain oil flow adjusting
NOTE
The oil tank should become nearly empty by the time
fuel is used up. Be sure to refill the oil tank every time
when refueling the saw.

Publicidad

loading