Publicidad
F31
F32
F33
46
English
10. Maintenance
3. Guide bar
When the guide bar is dismounted, remove sawdust in
the bar groove and the oiling port. (F31)
Grease the nose sprocket from the feeding port on the
tip of the bar. (F32)
(1) Oiling port (2) Grease port (3) Sprocket
4. Others
Check for fuel leakage and loose fastenings and
damage to major parts, especially handle joints and
guide bar mounting. If any defects are found, make
sure to have them repaired before operating the saw
again.
PERIODICAL SERVICE POINTS
1. Cylinder fins
Dust clogging between the cylinder fins will cause
overheating of the engine. Periodically check and clean
the cylinder fins after removing the air cleaner and the
cylinder cover. When installing the cylinder cover,
make sure that switch wires and grommets are
positioned correctly in place. (F33)
NOTE
Be sure to block the air intake hole.
2. Oil tank
With a wire hook, take out the oil filter through the filler
port and clean in gasoline. When putting the filter back
into the tank, make sure that it comes to the front right
corner. Also clean off dirt in the tank.
Publicidad
