Technics SL-100C Instrucciones De Funcionamiento página 20

Maintenance


Care of the parts
Thoroughly clean dust off the stylus and
record.
 Take off the head shell with the cartridge and
clean the stylus using a soft brush.
Brush from the base to the tip.
 Use a record cleaner to keep your records
clean.
Wipe the head shell terminals occasionally.
Wipe the head shell terminals with a soft cloth
and fit the head shell to the tone arm.
Turn the amplifier volume down or turn the
amplifier off before fitting or removing the
head shell.
Damage to your speakers can occur if the head
shell is moved while the volume is turned up.
 
Cleaning the dust cover and
cabinet
Wipe the dust cover and cabinet with a soft
cloth.
Do not touch the board while cleaning.
Otherwise, the player may fail.
When dirt is heavy, wring a wet cloth tightly to
wipe the dirt, and then wipe it with a soft cloth.
 Do not use solvents including benzene,
thinner, alcohol, kitchen detergent, a
chemical wiper, etc. This might cause the
exterior case to be deformed or the coating
to come off.
 Do not wipe the dust cover when it is in
place. Doing so may cause the tone arm to
be attracted towards the dust cover as a
result of the generated static electricity.
Be sure the dust cover is removed while
playing a record.
20
(20)
English
Head shell
terminals


Moving the unit
Repackage the unit in the packaging it came
in.
Keep the packaging materials after taking out
the goods.
If you no longer have the packaging, do the
following:
 Take off the turntable and turntable mat and
carefully wrap them.
 Remove the head shell and balance weight
from the tone arm and carefully wrap them.
 Clamp the tone arm with the arm clamp and
tape it in place.
 Carefully wrap the main unit in a blanket or
paper.
Repackaging


WEEE symbol
Disposal of the product outside the EU
countries
This symbol is valid within the EU
only.
Contact a local governmental office
or your dealer to confirm a right
manner of disposal.
Before repackaging,
remove the balance
weight and insert the
tone arm support
under the tone arm.