Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
4
Valve Trim Installation
D.
1
2
3
Temperature handle Installation
Secure temperature control knob (1) withscrew (2).
See next step (E) for securing temperature control
cover (3).
F.
2
1
3
4
Diverter Handle Installation
Slide diverter handle (1) onto diverter cartridge
stem (2), ensure that handle aligns with cartridge
stem.
Install set screw (3) using an allen wrench, place
set screw cover (4) over set screw and apply
pressure until cover is properly seated.
5
Potential scald or thermal shock injury could result due to cross flow if outlet at the shower is
blocked or restricted (e.g., pause control on showerhead). Be sure to point showerhead away
from you when re-starting flow or install inlet check valves on both supply lines to prevent
possible injury.
102019 Rev. A
All manuals and user guides at all-guides.com
6
E.
1
4
2
Snap temperature control cover over temperature
control knob by first aligning smaller tab (1) on cover
with receiving slot (2) on temperature knob. Swing
larger tab (3) to engage with snap feature (4). Note:
If dis-assembly is required, reverse this motion,
disengaging larger tab (3) from snap feature (4) first.
3
Publicidad
