Publicidad
Idiomas disponibles
Idiomas disponibles
A - ENGLISH
AFTER USE
1
When nished scrubbing, press the Scrub Off Switch (55). This will automatically raise, retract and stop all the machine systems (brush, squeegee, vacuum, solution and
detergent (EcoFlex models)). Then drive the machine to a service area for daily maintenance and review of other needed service up keep.
2
To empty the solution tank, remove the Solution Drain Hose (37) from its storage clamp. Direct the hose to a designated "DISPOSAL SITE" and remove the cap. Rinse the tank
with clean water.
3
To empty the recovery tank, pull the Recovery Tank Drain Hose (9) from its storage area. Direct the hose to a designated "DISPOSAL SITE" and remove the plug (hold the end
of the hose above the water level in the tank to avoid sudden, uncontrolled ow of waste water). The Recovery Tank Drain Hose can be squeezed to regulate the ow. Rinse
the recovery tank with clean water. Inspect the recovery and vacuum hoses; replace if kinked or damaged.
4
Remove the brushes, remove any string or banding that is wrapped around them, rinse in warm water and stand on end to dry. NOTE: Brushes should be ipped "end for end"
and rotated "front to back" daily for longest life.
5
Remove the squeegee, rinse it with warm water and re-install on mount.
6
Remove the Hopper (33) and clean thoroughly. Remove from the right side of the machine by opening the skirt, disconnecting the vacuum hose and then pulling out. NOTE:
Reconnect vacuum hose after re-installing.
7
Check the maintenance schedule and perform any required maintenance before storage
SHUTTING DOWN THE DIESEL ENGINE
1
Put all controls to the OFF position.
2
Raise the squeegee, the scrub brushes, and the brooms.
3
Push the Engine Speed Switch (51) to change to "Idle" speed and let the engine idle for 30 seconds.
4
Apply the Parking Brake (28).
5
Turn the Key Ignition Switch (50) OFF and remove the key.
SHUTTING DOWN THE LPG ENGINE
1
Put all controls to the OFF position.
2
Raise the squeegee, the scrub brushes, and the brooms.
3
Turn the service valve on LP gas tank OFF.
4
Push the Engine Speed Switch (51) to change to "Idle" speed and let the engine idle until all the LP gas is dispelled from the line.
5
Apply the Parking Brake (28).
6
Turn the Key Ignition Switch (50) OFF and remove the key.
IMPORTANT NOTE: During normal operation the engine will continue to run for a short period of time (1-3 seconds) after turning the key OFF until all fuel is dispelled from fuel
system.
MAINTENANCE SCHEDULE
Keep the machine in top condition by following the maintenance schedule closely. Maintenance intervals given are for average operating conditions. Machines used in severe
environments may require service more often.
Perform the "After Use" maintenance steps
*Check / Clean / Rotate & ip the Brushes
Check lter indicator and lights (hyd & air)
Purge Detergent System (EcoFlex only)
Inspect main scrub head skid plates(replace if worn to 1/8")
Change the hydraulic "charge" oil lter
Change reservoir hydraulic oil and lter
* See "INSTALL THE BRUSHES" section.
A - 20
INSTRUCTIONS FOR USE
MAINTENANCE ITEM
Check parking brake
Check engine oil
Check engine coolant level
Check hydraulic oil level
Drain / Check / Clean Tanks & Hoses
Check / Clean the Squeegee
Clean the Hopper
MAINTENANCE ITEM
Inspect and clean the Solution Filter
Clean radiator and oil cooler
Side Broom Maintenance
Clean solution trough
Inspect scrub housing skirts
Perform engine maintenance
Inspect and grease steering rack
Flush the radiator
Engine fuel lter(s) LPG
SC8000 - 56091075
DAILY
WEEKLY
X
X
X
X
X
X
X
X
X
X
15 hrs.
30 hrs.
150 hrs.
300 hrs.
X
X
X
X
X
X
X
X
X
500 hrs.
1000 hrs.
X
X
X
X
3/13
Publicidad
