ims PRO IMS SPOT 14500 Manual De Instrucciones página 46

3.4 - To complete the information in a report:
Each report can be filled in with the following information:
Operator,
Type of vehicle,
Repair order,
Registration,
Date of first registration,
Intervention,
Comments.
To enter this data, select a report and enter the information in the report header.
3.5 - Printing a report :
To print a report, select a report and click on the button
3.6 - Exporting the edition in PDF format:
To export an edition in PDF format, select a folder, then click on the button
An example of saving the parameters printed using the SPOT software is given below.
4 - Spot parameters
To switch to «Spot Parameter» mode, click on Spot Parameter in the Options menu.
The «Spot parameter» mode allows to use the operator to use spots set by the manufacturers. This mode also allows the user to choose his own
welding parameters.
- Insert the SD card supplied with the SPOT spot welder into the reader of your PC and select the correct disk in the drop-down menu.
- SPOT spot welders support up to 16 files that can contain up to 48 spot settings.
- The first file called «USER» cannot be deleted. It allows the user to add, modify or delete a spot parameter.
- The other files are reserved for the spot set by the manufacturers.
4.1 - Import a manufacturer spot parameter file :
4.2 - Add a configured spot in the USER file :
For a spot to be configured, it is possible to configure:
The pre-tightening stage
The pre-heating stage
The different pulses (4 pulses maximum)
And the hot and cold forging stage.
46
IMS SPOT 14500 TRAFO PRO
. A preview of the edition is displayed. Click on the button
Double-click in the first column and enter a manufacturer name.
Then double-click in the second column to select a manufacturer file previously downloaded from our
website.
The list of spots set by the manufacturer is displayed in the second list. Select a configured point to
view the chronogram and configured parameters.
To add a spot to the USER file, select the USER file from the file list and click on the button
right of the list of configured spots. Enter the name of the spot and press the TAB key or click outside
the list of configured spots to configure the welding parameters.
. A preview of the edition is displayed. Click on the button
EN
.
.
to the