V2 ELETTRONICA City1 Manual De Instrucciones página 49

DISPLAY DATA DESCRIPTION
Ch.tr Closing after passage
no - Closing after passage disabled
0.5"÷ 20.0' - Gate stop for a time to be set between 0.5" to 20'
Pa.tr no/Si Pausa dopo il transito
LP.PA no/Si Flashlight in pause
St.rt Operation modes
no - Start inputs from terminal board are disabled
StAn - Standard operation
AP.CH - Separated opening and closing commands
PrES - Manned operation
oroL - Timer operation
StoP STOP input
no - STOP input not available
invE - STOP command stops the gate: START command starts
ProS - STOP command stops the gate: pressing the START command
Fot 1 PHOTO 1 input
APCh - Input is available for the connection of the photocell
no - Not available
Fot 2 PHOTO 2 input
CFCh - Photocell is active in closing and also when the gate is still
no - Not available
Ch - Photocell is active during the closing
tESt Test of safety devices
no - Function not active
Foto - Test enabled only for photocells
CoSt - Test enabled only for safety edges
Ft.Co - Test enabled either for photocells or for safety edges
ShAd Photocell 2 shadow zone
no - Function disabled
F.ShA - FOTO2 disabling higher time
i.ShA - FOTO2 disabling lower time
CoS1 no/Si Border 1 input (fixed border)
CoS2 no/Si Border 2 input (mobile border)
FC.En no/Si End of stroke inputs
t.inA 0 ÷ 8 Max. gate quiescent time
ASM 0.5" ÷ 3.0" Anti-skid
no - Function disabled
SEnS 0 ÷ 10 Obstacle sensor level
Cont Counter viewing
tot. - Total number of completed cycles (views in thousands or in units)
Man - Number of cycles before the next request for service (such a number
APPr Automatic learning of the operation time
no - Function disabled
Go - Start up of the automatic learning procedure
FinE End of programming
no - It does not exit from the program menu
Si - It exits from the program menu by storing the setup parameters
City1 FUNCTION TABLE
moving in the opposite direction
gate continues the motion
has been rounded off to hundreds and it can be set up on 1000-step;
in case it is set up on 0, the request will be disabled and no will be viewed)
45 45
DEFAULT DEFAULT MEMO
SCor AntE DATA
no no
no no
no no
StAn StAn
no no
APCH no
CFCh CHCh
no no
no no
no no
no no
Si no
0 0
0.5" 0.5"
5 5
tot tot
no no
no no