Publicidad
Idiomas disponibles
Idiomas disponibles
2. A dust mask or respirator should be worn by all persons entering the work
area. The filter should be replaced daily or whenever the wearer has difficulty
breathing. See your local hardware store for the proper N.I.O.S.H. approved
dust mask.
3. NO EATING, DRINKING or SMOKING should be done in the work area to
prevent ingesting contaminated paint particles. Workers should wash and clean
up BEFORE eating, drinking or smoking. Articles of food, drink, or smoking
should not be left in the work area where dust would settle on them.
eNvIRoNMeNTAl SAfeTy
1. Paint should be removed in such a manner as to minimize the amount of dust
generated.
2. Areas where paint removal is occurring should be sealed with plastic sheeting of
4 mils thickness.
3. Sanding should be done in a manner to reduce tracking of paint dust outside the
work area.
cleANING ANd dISPoSAl
1. All surfaces in the work area should be vacuumed and thoroughly cleaned daily for
the duration of the sanding project. Vacuum filter bags should be changed frequently.
2. Plastic drop cloths should be gathered up and disposed of along with any dust
chips or other removal debris. They should be placed in sealed refuse receptacles
and disposed of through regular trash pick-up procedures. During clean up,
children and pregnant women should be kept away from the immediate work area.
3. All toys, washable furniture and utensils used by children should be washed
thoroughly before being used again.
Symbols
• The label on your tool may include the following symbols. The symbols and their
definitions are as follows:
V ..................volts
Hz ................hertz
min ..............minutes
or DC ...direct current
................Class I Construction
(grounded)
................Class II Construction
(double insulated)
bpm ............. beats per minute
protection
............Read instruction manual before use
................Use proper hearing protection
• When using an extension
cord, be sure to use one
heavy enough to carry the
current your product will
draw. An undersized cord
will cause a drop in line
voltage resulting in loss of
power and overheating.
The table shows the correct
size to use depending on
cord length and nameplate
ampere rating. If in doubt,
use the next heavier gauge.
The smaller the gauge number, the heavier the cord.
A ...................amperes
W ..................watts
or AC .......alternating current
n o .................no load speed
.................earthing terminal
................safety alert symbol
.../min or rpm...revolutions or
.................. Use proper respiratory
.................Use proper eye protection
Minimum Gauge for cord Sets
volts
120V
0-25
(0-7,6m) (7,6-15,2m) (15,2-30,4m) (30,4-45,7m)
240V
0-50
(0-15,2m) (15,2-30,4m) (30,4-60,9m) (60,9-91,4m)
Ampere Rating
More
Not more
Than
Than
0
-
6
18
6
-
10
18
10
-
12
16
12
-
16
14
5
reciprocation per minute
Total length of cord in feet
26-50
51-100
51-100
101-200
American Wire Gauge
16
16
16
14
16
14
12
Not Recommended
101-150
201-300
14
12
12
Publicidad
