Publicidad
Idiomas disponibles
Idiomas disponibles
operation
Switch
cAuTIoN:
Be sure switch is fully OFF before
plugging in the power cord.
• Plug in power cord.
• To turn the tool ON, hold it as shown in figure 8
and push the slide switch forward.
• To turn the tool OFF, push the slide switch
backward.
variable Speed dial
To operate the tool, select the speed setting you wish
with the speed dial, shown in figure 9, and slide the
ON/OFF switch forward. The speed setting can be
adjusted either with the tool on or off
cAuTIoN:
Because the oscillating tool has a
separate speed dial for setting the speed (1-6), the tool
will start at the speed where the speed dial is set.
The numbered positions,1 through 6 inscribed on the
variable speed dial, do not indicate any precise speed
but are good reference points. The higher the number,
the higher the tool speed.
The approximate speed at each setting is:
SPeed SeTTING
oScIllATIoNS PeR MINuTe
(Actual oscillations per minute on your tool may vary.)
Be sure to select the proper speed for your oscillating tool operation. In general, use lower
speeds (1-3) for cutting metal and PVC or plastic materials and use higher speeds (4-6) for
sanding, removal & wood cutting applications. For paint, varnish, or other finish removal,
use the lowest speed setting (1) to get the maximum life from the sanding sheet.
If in doubt about the proper speed for your operation, test the performance at low speed
settings and gradually increase until a comfortable speed is found.
Helpful Hints
• Always ensure the workpiece is firmly held or clamped to prevent movement. Any
movement of the material may affect the quality of the cutting or sanding finish.
• Do not start sanding without having the sandpaper attached to sanding platen.
• Use coarse grit paper to sand rough surfaces, medium grit for smooth surfaces and
fine grit for the finishing surfaces. If necessary, first make a test run on scrap material.
• Do not allow the sandpaper to wear away, it will damage the sanding pad.
• Excessive force will reduce the working efficiency and cause motor overload. Replacing
the accessory regularly will maintain optimum working efficiency.
• If the tool overheats, especially when used at low speed, set the speed to maximum
and run it with no load for 2-3 minutes to cool the motor. Avoid prolonged usage at
very low speeds. Always keep the blade sharp.
1
2
10,000
12,000
8
8
9
3
4
14,000
16,000
B
5
6
18,000
20,000
Publicidad
