Testing For Continuity (See Figure 6); Testing Diodes See (See Figure 7); Measuring Capacitance (35Xp-A Only) (See Figure 8) - Amprobe 5XP-A Manual De Uso

Find Quality Products Online at:
Testing for Continuity
(See Figure 6)

1. Set the Function Switch to .
2. Connect the test leads: Red to V , Black to COM.
3. Turn off power to the circuit being measured.
4. Discharge any capacitors that may influence the
reading.
5. Connect the test probes across the resistance or the
two points of test.
6. Listen for the tone that indicates continuity.
Testing Diodes
(See Figure 7)
1. Set the Function Switch to 
2. Connect the test leads: Red to V , Black to COM.
3. Turn off power to the circuit being measured.
4. Free at least one end of the diode from the circuit.
5. Connect the test probes across the diode.
6. Read the display. A good diode has a forward voltage
drop of about 0.6 V. An open or reverse biased diode
will read .
0o
Measuring Capacitance
(35XP-A only) (See Figure 8)
1. Set the Function Switch to the
2. Connect the test leads: Red to
3. Turn off power to the circuit being measured.
4. Discharge the capacitor using a 100 k resistor.
5. Free at least one end of the capacitor from the circuit.
6. Connect the test probes across the capacitor.
7. Read the display.
7
GlobalTestSupply
www.
.

function.
, Black to COM.
.com
sales@GlobalTestSupply.com