Assembly Instructions; Fitting Instructions - Belle Group PC X 12/36 Manual Del Operador

Assembly Instructions for Vibrator
1. Clean out Housing (9) with gun wash then
blow dry with compressed air.
2. Fit rear Bearing (3a) into Housing and push
Shaft (8) into Bearing.
3. Fit front Bearing (3b) onto Shaft and into
Housing.
4. Fit Bearing Cover 'B' (10) c/w Gasket (4a) to
the rear of the Housing.
5. Fit Oil Seal (6) into Bearing Cover 'A' (7).
6. Fit Bearing Cover 'A' c/w Gasket (4b) to the
front of the Housing.
7. Fit Woodruff Key (11) and Pulley (12) onto
Shaft.
8. Pour oil into oil drain hole in the housing
until oil just starts to trickle out.
9. Fit Copper Washer (2) and Oil Drain Plug (1).
10. Fit Vibrator onto Baseplate and tighten bolts
to a torque of 150Nm.
11. Run for approximately 2 minutes to ensure
oil does not leak from the Vibrator.
Paving Pad
The paving pad has been designed to be used
when tamping down paving slabs and block
pavers. However, it should not be used for
normal compaction work.
Before fi tting, make sure the paving pad you
have is the correct size and the correct type.
To fi t the Paving Pad (1), place the pad under
the plate ensuring the securing holes line up with
the holes on the front of the baseplate.
The securing coach bolts (4) should be passed
through the clamp strip (5) then the paving pad
(1) and fi nally through the baseplate. They are in
turn secured in place with the nut (2) and washer
(3).
Transporter Attachment
The Transporter Attachment enables the
operator to move the Compactor to the work
place with the minimum of effort.
To fi t the Transport Attachment, align the 2
indents on the Pivot Bracket (6) with the 2 holes
on the rear of the Baseplate (7).
The Transporter Attachment (8) can be secured
to the machine by passing the 2 x Securing
Bolts (9) through the 2 x Spring Washers (10)
and 2 x Washers (11), then through the indents
on the Pivot Bracket (6) and into the 2 holes in
the rear of the Baseplate (7). Tighten the 2 x
Securing Bolts (9) to a Torque setting of 50Nm.
The Transporter Attachment is now secure.
To use the Attachment, tilt the Compactor forward then swing the Attachment forward and under the machine. Finally, tilt the
Compactor back and onto the wheels.

Assembly Instructions

10
4a
3a
1
2
9

Fitting Instructions

3
4
5
15
12
11
8
3b
4b
2
7
6
GB
7
6
5
GB
1
9
10
11
8