Craftsman CMCHTS820D1 Manual De Instrucciones página 12

English
Fig. H
3. lEVEl hEDgEs (Fig. i) – To obtain exceptionally level
hedges a piece of string can be stretched along the
length of the hedge as a guide.
Fig. I
4. siDE TRiMMing hEDgEs (Fig. J) – Orient the trimmer
as shown and begin at the bottom and sweep up.
Fig. J
5. POWERsAW (Fig. K) – For branches too large for
6
the blade to cut, use the powersaw
the powersaw as close to the bottom of the branch
as possible. Place the powersaw shoe against the
branch. Turn the hedge trimmer on as described above,
allowing the tool to work at its own pace until the
branch is fully cut.
Fig. K
10
MAINTENANCE

Blade Maintenance (Fig. L)
The cutting blades are made from high quality, hardened
steel and with normal usage, they will not require
resharpening. However, if you accidentally hit a wire fence
(Fig. L), stones, glass, or other hard objects, you may put
a nick in the blade. There is no need to remove this nick
as long as it does not interfere with the movement of the
blade. If it does interfere, remove the battery and use a fine
toothed file or sharpening stone to remove the nick. If you
drop the trimmer, carefully inspect it for damage. If the
blade is bent, housing cracked, handles broken or if you see
any other condition that may affect the trimmer's operation
contact your local authorized service center for repairs
before putting it back into use.
Fig. L
Cleaning
11
. Position


Blade Lubrication (Fig. M)
1. After use, remove the battery.
2. Carefully apply a resin solvent to the exposed blades.
WARNING:
To reduce the risk of
serious personal injury, turn unit off and remove
the battery pack before making any adjustments
or removing/installing attachments or
accessories. An accidental start-up can cause injury.
WARNING:
Blow dirt and dust out
of all air vents with clean, dry air at least once a
week. To minimize the risk of eye injury, always
wear ANSI Z87.1 approved eye protection when
performing this procedure.
WARNING:
Never use solvents or other
harsh chemicals for cleaning the non-metallic parts
of the tool. These chemicals may weaken the plastic
materials used in these parts. Use a cloth dampened
only with water and mild soap. Never let any liquid
get inside the tool; never immerse any part of the tool
into a liquid.