Flex LB 17-11 125 Manual De Instrucciones página 23

LB 17-11 125 / LBE 17-11 125
Safety Brake System
NOTE
The angle grinder features a run-out brake.
The grinder is stopped within a matter of
seconds when it is switched off.
If power is cut or the mains plug pulled while
the tool is in use, the grinder will continue to
run without being braked.
Preselecting the speed
(LB 17-11 125)
To set the operating speed, move the dial

to the required value.
CAUTION!
Risk of injury due to destruction of the tool.
Use the appropriate tool for the job.
NOTE
If an overload or overheating occurs during
continues operation, the power tool auto-
matically reduces the speed until the power
tool has cooled down adequately.
Adjusting the guard
To adjust the tool to the task at hand, the
guard hood can be adjusted by 12 notches
on 360° without a tool.
CAUTION!
Risk of injury! Wear protective gloves.
Pull out the mains plug.

Turn guard hood opposite to the

direction-of-rotation arrow on the gear
head to the required position.
Work instructions
NOTE
When the power tool is switched off,
the grinding tool continues running briefly.
Rough-grinding
WARNING!
Never use cutting-off wheels for rough-
grinding.
– Angle of wheel 20–40° for best cutting
performance.
– Applying moderate pressure, move the
angle grinder backwards and forwards.
As a result, the workpiece will not
become too hot and there will be no
discoloration; nor will there be any
grooves.
Cut-off grinding
WARNING!
A special cutting guard must be used for
cutting.
See manufacturer's accessories catalogue.
– Do not press, tilt or oscillate the power
tool.
– The angle grinder must always be
operated backwards.
23